車庫門在我們的生活中隨處可見，因其性高以及本身性能良好為人所滿足，當然也會在使用期間出現問題，經過維修后記得進行檢查工作，這樣才能知道是否問題解決完，那要檢查什么事項呢？

　　Garage door can be seen everywhere in our life, because of its high safety and good performance is satisfied, of course, there will be problems during the use, remember to check the work after maintenance, so as to know whether the problem is solved, what matters to check?

　　去除濟南車庫門電機和傳動鏈表面的灰塵，并加入潤滑油；濟南車庫門附近的煙霧/溫度感應檢查車庫門的功能。檢查電動制動手動開關和手動啟動裝置；檢查控制箱內的部件，擰緊端子，清潔箱體內部和表面灰塵；系統維護按維護計劃進行，并記錄在設備的日常維護表中。

　　Remove dust on the surface of motor and transmission chain of Jinan garage door, and add lubricating oil; Ji 'nan garage door near the smoke/temperature sensor check the function of the garage door. Check electric brake manual switch and manual starting device; Check the components in the control box, tighten the terminals, and clean the dust inside and on the surface of the box; System maintenance is performed according to the maintenance plan and recorded in the routine maintenance table.

　　手動控制濟南車庫門，檢查運行狀態，調整上下行程開關的位置，使?jié)宪噹扉T在合適的位置打開或關閉，測試過程嚴格防止?jié)宪噹扉T的頂部或底部；檢查濟南車庫門的上下行程開關，并為開關導軌增加潤滑。

　　Manual control of ji 'nan garage door, check the operation state, adjust the position of the upper and lower travel switch, so that ji 'nan garage door in the appropriate position to open or close, the test process strictly prevent the top or bottom of ji 'nan garage door; Check the up and down travel switch of ji 'nan garage door, and increase lubrication for the switch guide rail.

　　另外，在使用濟南車庫門時，盡量保持控制器和電壓的穩定，禁止安裝在非常潮濕的環境中。另外，不要隨意打開遙控器。如果發現門上有電線纏繞和打結，應及時處理。注意通道是否堵塞，阻礙門體下降。如有異常反應，立即停止電機運行。

　　In addition, when using jinan garage door, try to maintain the stability of the controller and voltage, and prohibit installation in a very humid environment. Also, don't turn on the remote at random. If you find wire winding and knotting on the door, you should deal with it immediately. Pay attention to whether the passage is blocked, blocking the door body down. In case of abnormal reaction, stop motor operation immediately.

　　濟南車庫門維修后要檢查什么事項？維修之后的檢查工作是必做的項目，不能忽略掉，只有進行下去您才能知道車庫門是否修理好了、是否還有問題存在。更多內容就來網站www.cxfk.net.cn咨詢吧！

　　What matters should be checked after the maintenance of jinan garage door? The inspection work after maintenance is a necessary project, which can not be ignored. Only by going on can you know whether the garage door is repaired and whether there are problems. More content to the website www.cxfk.net.cn consultation!